CrustCrawler Logo

CrustCrawler Robotics

  • Mon-Fri 8:00-5:00pm (GMT-7)
 
 
 
 
 
 
 
 
 
 
 

Electronics Store


Electronics | Cables | Manuals
Image Product Description Price Order
BS2
BASIC Stamp IC
20 MHz
1.2"x0.6"x0.4"
 ~4,000 instructions/sec.
2K Bytes, ~500 instructions
16 +2 Dedicated Serial
5 - 12 vdc
42 PBasic commands
Serial Port (9600 baud)
$49.00
BASIC Stamp 2p 24-Pin Module
24-pin DIP
1.2"x0.6"x0.4"
~12,000 instructions/sec.
38 Bytes RAM
128 Bytes Scratch Pad RAM
8x2K Bytes EEPROM
16 +2 Dedicated Serial
5 - 12 vdc
61 PBasic commands
Serial Port (9600 baud)
$79.00

 

Board of Education
Mechanically interlocked power supply to prevent dual connection of wall-pack and 9-volt battery
DB9 connector for BS2-IC programming and serial communication during run-time
P0 - P15 I/O pins, Vdd and Vss connections brought adjacent to 5.1 x 3.5 cm (2" x 1 3/8") breadboard area
Includes set of ten (10) color-coded 22 gauge wires
Female 10-pin dual row connector for optional AppMods (more breadboard space)
Traces on top of the board show connections between BS2-IC and breadboard connections
$65.00
Infrared distance detection kit
(1) Schematic
(1) Sharp GP2D12 with cable
(1) Max 1112 8-bit A/D converter DIP
(1) 1k Ω resistors
(1) 1.5k Ω resistor
(1) 10µF tantalum capacitor
$29.95 Out of Stock
Parallax PING)))™ Ultrasonic Sensor
Range - 2cm to 3.35m (~.8" to 11.3')
Supply Voltage: 5V +/-10% (Absolute: Minimum 4.5V, Maximum 6V)
Supply Current: 30 mA typ; 35 mA max
3-pin interface (power, ground, signal)
20 mA power consumption
Narrow acceptance angle
Simple pulse in / pulse out communication
Indicator LED shows measurement in progress
Input Trigger - positive TTL pulse, 2 uS min, 5 uS typ.
Echo Pulse - positive TTL pulse, 115 uS to 18.5 mS
Echo Hold-off - 350 uS from fall of Trigger pulse
Burst Frequency - 40 kHz for 200 uS
Size - 22 mm H x 46 mm W x 16 mm D (0.85 in x 1.8 in x 0.6 in) v
$24.95
LCD AppMod

The module has a 2x8 display, four pushbuttons, and will connect to any programming board that has a 2x10 AppMod Header. The display uses a 4-bit parallel interface (Hitachi HD44780 compatible) to interface to the microcontroller and includes a contrast knob for display adjustment. This low-cost display is excellent for your smaller projects.

  • 2x8 LCD Display
  • 4 Buttons
  • Parallax AppMod Header Connection
  • Power Requirements: 5 V @ 15 mA (quiescent current)
  • Communication: 4-Bit parallel interface (Hitachi HD44780 compatible)
  • Dimensions: 2.4 x 2 x 0.8 in (60 x 50 x 20 mm)
  • Operating Temperature: 32 to 158 °F (0 to 70 °C)
$14.99
PSC
Parallax Servo Controller
2400 to 38k4 Baud rate
16 Servo channels
63 ramp rates (0.75 - 60 seconds) Position Reporting
Daisy Chain 2 PSCs (32 servo channels)
16-bit PWM
0 - 180 degree servo rotation
2 microseconds per step Compatible with different types of AppMods on the same serial line
$39.95
3300 NiMh Battery Pack
2x3 1.2V 3300mAh battery cells
$54.99
Servo Power Supply
Servo Power Supply
This powerful transformer was custom selected for use with the SG5-UT robotic arm. A male power connector screws right into the SG5_UT board holder for a quick and easy transformer connection. This transformer is highly recommended for continuous use of the SG5-UT robotic arm without the worry of constantly re-charging a battery pack
(1) 15W, 2 prong, 6V, 2.5A Transformer
(1) SG5_UT male Power adaptor plug
$26.95
BOE/Stamp Power Supply
Board of Education /Basic Stamp power
This transformer is highly recommended for continuous use of the BOE/Basic Stamp combination without the worry of constantly re-charging a battery pack.
9v 500ma supply
$8.95

6 Channel FM Radio Control System
The all new Laser 6 radio systems are packed with features. With an ergonomically designed case the Laser 6 is an excellent choice for a feature packed economical 6 channel radio system for robot control.

Kit includes:
6-Channel Radio
Duel conversion RCD 3500 Receiver
(2) Hitec 322HD Servos
Nicd Battery (transmitter)
117V charger

$159.00

Electronics | Cables | Manuals
Image Product Description Price Order
12" Heavy Duty servo wire extension $4.00
18" Heavy Duty servo wire extension $4.39

Electronics | Cables | Manuals
Image Product Description Price Order
BASIC Stamp Manual Version 2.0 $34.95